Power Mold Engineering Company Limited Company Information

Current Status : Dissolved


Power Mold Engineering Company Limited's Hong Kong CR Number is 1042736. Incorporation Date is 04-MAY-2006. It's Winding up Mode is . Dissolution date is 13-JUL-2012. Power Mold Engineering Company Limited company is of Private company limited by shares Type.
Additional Remarks on the Power Mold Engineering Company Limited company are Dissolved by Striking Off.

Company Data

CRN1042736
Company NamePower Mold Engineering Company Limited
Chinese Name力茂工程有限公司
Active StatusDissolved
Register of ChargesUnavailable
TypePrivate company limited by shares
See other companies with same Type - Private company limited by shares
Winding Up Mode
Date of Incorporation04-MAY-2006
See companies with same Incorporation Date - 04-MAY-2006
Date of Dissolution13-JUL-2012
RemarksDissolved by Striking Off
Important Note
Tagsengineering   mold   power   
Find Similar Companies by these tags.

Company Name History Information :

Effective DatePrevious Name
Power Mold Engineering Company Limited04-MAY-2006

FAQs:

When was Power Mold Engineering Company Limited incorporated?

Power Mold Engineering Company Limited was incorporated on 04-MAY-2006 in Hongkong.

What is the type of Power Mold Engineering Company Limited?

Power Mold Engineering Company Limited is classified as Private company limited by shares.

What is the current status of Power Mold Engineering Company Limited Company?

The status of Power Mold Engineering Company Limited is Dissolved.

What is the CR Number of Power Mold Engineering Company Limited?

The CR Number of Power Mold Engineering Company Limited is 1042736.

* We are trying our best to keep all the data correct and up-to-date. It should be noted that it is not the primary source of the information on the company Power Mold Engineering Company Limited. The official registry should always be referred for latest information.

Last Updated on 26-06-2016.

Check other companies added on 26-06-2016

Check out Companies Incorporated on 04-MAY-2006: